|
|
 |
|
|
|
CA3420A Supplier, CA3420A on Stock |
|||
| CA3420A CA3420A PDF ! Fully integrated, PLL-stabilized VCO ! Flexible frequency range from 800 MHz to 930 MHz ! ASK achieved by on/off keying of internal power amplifier ! FM possible with external varactor ! Wide power supply range from 2.2 V to 5.5 V ! High over-all frequency accuracy ! Very low standby current CA3420A Datasheet 120MHz bandwidth at +24dBm output Low distortion (2nd/3rd: -60/-62dBc @ 20MHz and 10dBm) Output short circuit protection User-definable output impedance, gain, and compensation Internal current limiting Direct replacement for CLC560 CA3420A Suppliers The TPS40052 is part of a family of high-voltage, wide input, synchronous, step-down converters. The TPS40052 offers design flexibility with a variety of user programmable functions, including soft-start, operating frequency, high-side current limit, and loop compensation. Frequency Gain (CDMA Modulation) Output Power (CDMA) Adjacent Channel Power Rejection @ 28.0 dBm Alternate Channel Power Rejection @ 28.0 dBm Power Added Efficiency (CDMA) @ 28.0 dBm Output Power (AMPS) Power Added Efficiency (AMPS) Gain (AMPS) Output Stability Quiescent Current (No RF) Supply Voltage Input Return Loss Noise Figure Harmonics, 2f, 3f, 4f Power Down On/Off Time Using Application Schematic. Tuned for CDMA. @ 885 KHz offset from band center. @ 1980 KHz offset from band center. No oscillation all phases ( RF power up to PSAT ) The high-speed switching of LVDS signals requires the use of a line impedance matching resistor at the receiving-end of the cable or transmission media. TI offers both the CA3420A, which integrates the terminating resistor for point-to-point applications, and its companion the SN65LVDS2, which requires an external resistor. The packaging, low power, low EMI, high ESD tolerance, and wide supply voltage range make these devices ideal for battery-powered applications. 1. Ultra-small and thin size achieved through use of high density mounting technology. 2. SMD type can be surface mounted. 3. High sensitivity supports communications of up to 10m. 4. UART, USB and PCMIF interfaces enable wide range of applications. 5. Conforms to FCC, CE and other countries'EMI standards. 6. Supports Bluetooth Class2 (CLASS 1-supporting WML-C07 also available.). 7. Two types of models: With/without an antenna are provided. 1. Ultra-small and thin size achieved through use of high density mounting technology. 2. SMD type can be surface mounted. 3. High sensitivity supports communications of up to 10m. 4. UART, USB and PCMIF interfaces enable wide range of applications. 5. Conforms to FCC, CE and other countries'EMI standards. 6. Supports Bluetooth Class2 (CLASS 1-supporting WML-C07 also available.). 7. Two types of models: With/without an antenna are provided. |
|
||
